(
AUTO REV. (AUTO REVERSE)
– to select the desired tape playback modes.
)
TIMER
– to display timer or set the timer.
¡
REPEAT
– to playback track(s)/disc(s)/program repeatedly.
™
SHUFFLE
– to playback all available discs and their tracks/
program in random order.
£
TIMER ON/OFF
– to activate or deactivate the timer function.
≤
SLEEP
– to activate, deactivate or set the sleep timer
function.
∞
SNOOZE
– to temporarily deactivate the wake up timer.
§
CD RESUME
– to continue playback from the last selected track
after an interruption (only when the CD source
is still in the active mode).
– to resume the last selected CD mode.
≥
CLOCK
– to display clock or set the clock.
•
B
– to switch the system to Standby mode.
Notes for remote control:
– First, select the source you wish to
control by pressing one of the source select
keys on the remote control (CD 123 or
TUNER, for example).
– Then select the desired function (
É
,
í
,
ë
, for example).
A
Power
Before connecting the AC power cord to the
wall outlet, ensure that the following are done;
– If your system is equipped with a Voltage
Selector, set the VOLTAGE SELECTOR to the
local power line voltage.
– All other connections have been made.
Preparations
To resume playback from the last
selected track
● In CD stop or pause mode, press CD
RESUME on the remote control to start
playback again from where you have stopped.
Notes:
– Resume will not be available if you have
changed the disc, opened the disc tray or
disconnected the system the power supply.
– Select CD RESUME in any other source mode
will only able to resume the last selected CD active
mode (for example, CD stop or playback).
Clock/Timer
To activate/deactivate the TIMER
● Press TIMER ON/OFF repeatedly on the
remote control.
➜ If activated, the last set timer information will
be shown for a few seconds and
TIMER
will
appear on the display.
➜ If deactivated, “
OFFOFF
OFFOFF
OFF” will be displayed.
To deactivate the wake up timer (five
minutes interval)
● After timer wake up, press SNOOZE on the
remote control.
➜ The system will switch to standby mode for
five minutes. After then, it resumes the timer last
selected source again.
● To cancel the snooze function, press SNOOZE
again.
Note:
–To enable the snooze function, it should be done
within 30 minutes after timer wake up.
Changing Tuning Grid
(available for
/21/21M versions)
In North and South America, the frequency step
between adjacent channels in the MW band is
10 kHz (9 kHz in some areas). The preset
frequency step in the factory is 9 kHz.
Changing the tuning grid will erase all
previously stored preset radio stations.
1
Disconnect the system from the AC power
supply (pull out the AC power cord).
2
While holding down TUNER and á on the
system, reconnect the system to the AC power
supply.
➜ The display will show "GRID 9" or "GRID
10".
Notes:
– GRID 9 and GRID 10 indicate that the tuning
grid is in step of 9 kHz and 10 kHz respectively.
– The FM tuning grid also will be changed from
50 kHz to 100 kHz or vice versa.
Radio Reception
To Next Page
Loading...
