34
For assistance, call the Support Center at 1-888-632-3261.
6. Turnonthedispenser.
• Slidethepowerswitchuptothe“On”position.
• ThePhilipsMedicationDispenserwillconductaself-test.Thedisplaywillshow:
After a few seconds, the red LED will light up and “System OK, ready for setup” will be
announced and displayed.
7. CalltheSupportCenter.
Helpful Hint: Use a cell phone to call the Support Center. This allows you to remain
on the line with the Support Specialist through the entire installation.
• CalltheSupportCenterat1-888-632-3261.TelltheSupportSpecialistthatyouare
readytoactivatetheservice.Youwillneedtoprovidethepatient’snameandthe
serial number of the Philips Medication Dispenser. The serial number is listed on the
bottom of the label inside the door.
Serial number
Power switch