Philips pm3232 - Page 49

95
If the wiring board
must be replaced,
also
unsolder
the remaining
connection
wires along
the
sides of
the
board,
including the connection
of
the
mains
cable
to
the ILLUM
potentiometer
and the connections
to
the
valve
holder of the c.r.t.
Note: When replacing the
board,
make
sure
that
the shafts of the
ILLUM, FOCUS
and INTENS potentiometers
fit properly in the
coupling
bushes
0
(Fig. 3.11.).
Fig.
3.
19.
Dismantling
Fig.
3.20.
Supply
unit
swiveled out