Phoenix Contact FL MGUARD RS2000 TX/TX VPN - Page 174

FL MGUARD GT/GT
174
PHOENIX CONTACT 105656_en_05
SFP slots
Inserted SFP modules are detected automatically when the device is switched on and the
corresponding RJ45 port is disabled. Configuration of the SFP modules is not required be-
cause the modules are configured automatically (as of firmware 8.1.x).
The device supports both SFP modules with 100 and 1000 Mbps. Reboot the device when
you change the speed of the used SPFs.
Use of the following SFP modules is recommended:
– FL SFP SX, 2891754
– FL SFP LX, 2891767
– FL SFP LH, 2989912
– FL SFP FX, 2891081
– FL SFP FX SM, 2891082
Elements of the SFP modules
The SFP slots are used by SFP modules (FO fiberglass
modules in SFP format). By selecting the SFP modules, the
user can specify whether the switch has multi-mode or sin-
gle-mode fiber optic ports, for example.
Inserting the SFP modules
• Insert the SFP modules in the relevant slots.
• Ensure correct mechanical alignment of the SFP mod-
ules.
Connecting the FO cable
• Ensure correct mechanical alignment when inserting
the fiber optic plugs.
Removing the fiber optic plugs
• Press the arresting latch (A) and pull out the plug (B).
Elektrische
Anschlusskontakte
Mechanische
Verriegelung
LWL-
Anschluss
Ausrasthebel
Mechanical
locking
Electrical connec-
tion contacts
Release latch
FO connection
A
B