FL MGUARD PCI(E)4000
208
PHOENIX CONTACT 105656_en_05
9.8 Restart, recovery procedure, and flashing the firm-
ware
The Reset button is used to set the device to one of the following states:
– Performing a restart
– Performing a recovery procedure
– Flashing the firmware/rescue procedure
Figure 9-6 Reset button
9.8.1 Performing a restart
Objective The device is restarted with the configured settings.
Action • Press the Reset button until the STAT LED lights up orange.
• Alternatively, restart the computer that contains the FL MGUARD PCI card.
To Next Page
Loading...
