FL MGUARD PCI(E)4000
105656_en_05 PHOENIX CONTACT 203
9.5.3 Starting up FL MGUARD PCI4000 via BootP
In initial startup mode, the FL MGUARD PCI4000 additionally starts a BootP client on the in-
ternal network interface (LAN 1). The BootP client is compatible with the “IPAssign” BootP
servers from Phoenix Contact as well as “DHCPD” under Linux.
This software can be downloaded free of charge at phoenixcontact.net/products.
If an non-configured FL MGUARD PCI4000 accesses a BootP server after booting, the
BootP protocol assigns an IP address, a subnet mask, and optionally a default gateway of
the internal network interface to the FL MGUARD PCI4000. These parameters are saved in
the device which can then be immediately accessed under these parameters.
• Enter the address assigned via BootP in the browser: e.g., https://192.168.1.1/
Configure the device as described in “Configuring the FL MGUARD PCI4000” on page 201.
IP address assignment using IPAssign is described in detail in “Assigning the IP address
using IPAssign.exe” on page 265.
To Next Page
Loading...
