EasyManuals Logo
Home>Phoenix Contact>Network Router>FL MGUARD RS2000 TX/TX VPN

Phoenix Contact FL MGUARD RS2000 TX/TX VPN User Manual

Phoenix Contact FL MGUARD RS2000 TX/TX VPN
270 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #253 background imageLoading...
Page #253 background image
FL MGUARD DELTA TX/TX
105656_en_05 PHOENIX CONTACT 253
12.5.1 IP address 192.168.1.1
To access the configuration interface, it may be necessary to adapt the network configura-
tion of your computer.
Under Windows 7, proceed as follows:
In the Control Panel, open the “Network and Sharing Center”.
Click on “LAN connection”. (The “LAN connection” item is only displayed if a connection
exists from the LAN interface on the computer to a mGuard device in operation or an-
other partner).
Click on “Properties”.
Select the menu item “Internet protocol Version 4 (TCP/IPv4)”.
Click on “Properties”.
First select “Use the following IP address” under “Internet Protocol Version 4 Proper-
ties”, then enter the following address, for example:
12.5.2 IP address https://1.1.1.1/
With a configured network
interface
In order for the device to be addressed via address https://1.1.1.1/, it must be connected
to a configured network interface. This is the case if it is connected in an existing network
connection and if the default gateway can be accessed via the WAN port of the device at
the same time.
In this case, the web browser establishes a connection to the mGuard configuration inter-
face after the address https://1.1.1.1/ is entered (see “Establishing a local configuration con-
nection” on page 255). Continue from this point.
In Stealth mode, the device can be accessed via the LAN interface via IP address
192.168.1.1 within network 192.168.1.0/24, if one of the following conditions applies.
The device is in the delivery state.
The device was reset to the default settings via the web interface and restarted.
The rescue procedure (flashing of the device) or the recovery procedure has been
performed.
IP address: 192.168.1.2
Subnet mask: 255.255.255.0
Default gateway: 192.168.1.1
Depending on the configuration of the device, it may then be necessary to adapt the net-
work interface of the locally connected computer or network accordingly.
After access via IP address 1.1.1.1, the FL MGUARD can no longer be accessed via IP
address 192.168.1.1

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Phoenix Contact FL MGUARD RS2000 TX/TX VPN and is the answer not in the manual?

Phoenix Contact FL MGUARD RS2000 TX/TX VPN Specifications

General IconGeneral
BrandPhoenix Contact
ModelFL MGUARD RS2000 TX/TX VPN
CategoryNetwork Router
LanguageEnglish

Related product manuals