TC MGUARD RS4000/RS2000 4G
84
PHOENIX CONTACT 105656_en_05
4.3.4 Antennas
To establish a mobile communication connection, matching antennas must be connected
to the devices. TC MGUARD RS4000/RS2000 4G have two SMA round plugs for the anten-
nas. For optimum LTE reception, always connect two antennas to the devices.
We recommend the multiband mobile phone antenna with mounting bracket for outdoor in-
stallation (TC ANT MOBILE WALL 5M, Article No. 2702273). Also refer to the antenna doc-
umentation at phoenixcontact.net/product/2702273
.
In the case of the TC MGUARD RS2000 4G, the WAN is only available via the mobile net-
work, as a WAN interface is not available. The mobile network function is preset. The
TC MGUARD RS2000 4G can only be operated in Router mode.
Connecting antennas
Figure 4-5 Antenna connection
• Connect one or two suitable antennas to the antenna connection.
Antenna connection
– SMA for mobile communication (ANT1/ANT2“, primary/secondary antenna)
–RSMA (GPS)
• If the bar graph indicates good or very good reception, affix the antenna (see “Bar
graph” on page 79).
NOTE: Health effects due to RF radiation
A distance of at least 20 cm between persons and the antennas must be maintained
during normal operation.
NOTE: Removing operator permissions
Operation of the wireless system is only permitted with accessories supplied by
Phoenix Contact. The use of other accessory components may invalidate the operating
license.
You can find the approved accessories for this wireless system listed with the product at:
phoenixcontact.net/products.
To Next Page
Loading...
