or “1” are considered to be long-distance, while calls that begin with a digit 2-9 are considered to be “lo-
cal,” but this can be modified as needed to match your dialing patterns. For example, toll-free 800, 888,
877, 866, etc. numbers are usually set up as local calls.
IMPORTANT: You cannot turn local calls on for an extension that has local calls disabled by the in-
staller.
IMPORTANT: 9-1-1 can always be dialed no matter what this setting is. In addition, calls that are set by
the installer to “Always Allow” can be dialed regardless of how local calling permissions are set.
Ext-to-Ext Calls
If the “Ext-to-Ext Calls” button is lit, the selected extension is allowed to make calls to other extensions. If
the light on this button is off, the selected extension is prevented from calling other extensions.
To change this calling permission for the selected extension, simply press the “Ext-to-Ext Calls” button.
Within one second, the light will change (from on to off or from off to on).
IMPORTANT: You cannot turn extension-to-extension calls on for an extension that has extension-to-
extension calls disabled by the installer.
Do Not Disturb
If the “Do Not Disturb” button is lit, the selected extension is in Do Not Disturb mode. In this mode, any
calls that are made or transferred to the extension will receive a busy signal, or will go directly to voice
mail if optional Voice Mail is installed.
To change the Do Not Disturb setting for the selected extension, simply press the “Do Not Disturb” button.
Within one second, the light will change (from on to off or from off to on).
Message Waiting
If the “Message Waiting” button is lit, the selected extension has its message-waiting status set to on. If the
room phone has a standard hotel message-waiting lamp, this lamp will be blinking.
Note that the message-waiting lamp can be set or cleared independently of the voice mail messages, but if
the optional Voice Mail Card is installed, the message-waiting lamp will be turned on automatically when a
message is left for the extension, and will be turned off when voice mail is cleared or the mailbox user
erases their messages.
To change the message-waiting lamp setting for the selected extension, simply press the “Message Wait-
ing” button. Within one second, the light will change (from on to off or from off to on).
Check Bill Total
The “Check Bill Total” button works only if the optional Call Accounting Card is installed. This button’s
lamp will light when you press the button, at which time the display will read:
18 PhoneSuite
®
Console User’s Manual rev. 081106
To Next Page
Loading...