PhoneSuite Console - A45 Check All Extensions in; Extension in

PhoneSuite
®
Console User’s Manual rev. 081106 51
end of the call has hung up, and so PhoneSuite attempts to keep the call active. If you suspect that a trunk
is hung (e.g., a trunk light is lit but no extension lights are lit and the call is not ringing to the console), you
can connect to the trunk and clear the inactive call. This is done by dialing A44 and dialing the appropriate
trunk number on the keypad. You will hear busy-tone and can press “C” to override this and connect to the
trunk. You can then press “D” to exit from the call; if the trunk is hung, it will be automatically cleared
when you exit. If it turns out there is a call in progress, the call will remain in place after you press C.
A45 Check All Extensions In
The command is used to set every single extension in PhoneSuite to a checked-in status. This command is
the same as using the “Check In/Out” feature-key button (or running the A10 command) for every exten-
sion; for more information on the Check In function, see page 15 and page 27). In normal operation, this
com
mand is almost never used, but it may be run after PhoneSuite has first been installed and set up.
To invoke this command, dial A-4-5 on the console keypad. The display will read:
Enter to Clr All
Ext to Check-In
Press Enter (#) to set ALL extensions to checked-in status, or press “D” to exit from this function without
changing each extension’s checked-in/out status.