22 PhoneSuite
®
Console User’s Manual rev. 081106
Print Calls EEE
Enter=OK D=Exit
Press Enter (#) to print the report, or “D” to quit without printing. Note that this report will print on any
printer that is set up by the installer to print “A Reports.” To stop printing partway through the report, press
“D.”
This report contains a detailed list of all the calls that have been priced and stored for the selected exten-
sion, including the trunk used for placing the call, the time and date the call started, the number dialed, the
type of call placed, the duration of the call (in minutes and tenths of a minute), and the cost of the call. At
the bottom of the report, the total number of calls, the total sum of minutes, and the total cost of the calls
are all shown.
Status Report
The “Status Report” button is used to print a report that shows the current room status setting for all exten-
sions. When this feature-key button is pressed, the display will read:
Prt Room Status
Report=Ent D=Ex
Press Enter (#) to print the report, or Exit (D) to quit without printing. The Status Report, which includes
all settings (except wakeup calls) for all extensions, will be printed. See the “Reports” section later in this
manual for a detailed description of this report. Note: to stop printing partway through the report, press
“D.”
Night Mode
Night Mode can be turned on or off whenever desired, by pressing the “Night Mode” button. If the “Night
Mode” button’s lamp is flashing, PhoneSuite is currently in Night Mode; if this lamp is unlit, PhoneSuite is
in Day Mode. The system may also be configured to enter and leave night mode automatically. For detailed
information on Night Mode, see page 47.
To Next Page
Loading...