A26 Display Extension Outbound Call Count (Model 64 only)
This command will display a count of the outbound trunk calls lasting more than thirty seconds made from
a particular extension. From the console idle prompt, press A-2-6. The display will show:
EEE Out Call Cnt
C=Clear D=Exit
Enter the two- or three-digit extension number. The “Cnt” portion of the display will immediately change
to a three-digit number that indicates the number of outbound trunks calls made from that extension. Press
“D” to exit the command or “C” to clear the call count and exit. A check-in operation will automatically
clear the count for that extension. To display the count of both outbound and inbound trunk calls to an ex-
tension, use command A27 described below.
A27 Display Extension Call Count (Model 64 only)
This command will display a total count of the outbound trunk calls lasting more than thirty seconds made
from and inbound calls received by a particular extension. From the console idle prompt, press A-2-7. The
display will show:
EEE All Call Cnt
C=Clear D=Exit
Enter the two- or three-digit extension number. The “Cnt” portion of the display will immediately change
to a three-digit number that indicates the total number of outbound trunks calls made from and inbound
calls received by that extension. Press “D” to exit the command or “C” to clear the call count and exit. A
check-in operation will automatically clear the count for that extension. To view just the outbound call
count, use command A26 described above.
System Startup Message
Whenever PhoneSuite is powered up from an unpowered state, it prints an initialization message to its se-
rial and parallel ports:
MM/DD/YY HH:MM PhoneSuite VX.XXX NNN
Where MM/DD/YY is the current PhoneSuite date, HH:MM is the PhoneSuite current time, and NNN is
the reset counter that will increment each time PhoneSuite is restarted (this can be used to test for frequent
power failure occurrences). After this information, the version number of the Main Board software is
shown.
Note: The initialization message only appears when new power is applied, is sent to all output ports, and
cannot be turned off.
System Event Messages
As system events occur, messages are printed to notify you about them. A message will be printed any time
a change is made to one of the following: an extension’s Message-Waiting lamp status, an extension’s
38 PhoneSuite
®
Console User’s Manual rev. 081106
To Next Page
Loading...