PHOTONIS | 42
NVT 200-LC-0103
Revision: D
Page 42 of 43
CAUTION
To avoid damage to the camera hardware, do not immerse
the camera in any type of liquid, and do not pour any liquid
on, or in the camera.
5. Prior to long term storage, remove any objective lens and clean according to manufacturer’s
instructions.
6. It is recommended that lenses be cleaned and wrapped in lens paper or a dry lint free cloth for
storage.
7. After removal of the objective lens, check the sensor and board, visible through the CS mount,
for dust or debris.
8. If necessary, clean the sensor and board with low pressure, dry, compressed air or nitrogen. If
there are fingerprints or other oily residue evident on the sensor glass, the sensor glass may be
cleaned with a lint free cotton-tipped applicator and Methanol.
9. If the sensor is cleaned using isopropyl alcohol, allow the sensor to air dry.
10. Once the sensor is fully dry, install the protective cap received with the camera over the CS
mount.
11. Place the camera in a protective ESD bag and package.
12. For long term storage, a humidity and temperature controlled environment is recommended,
however, the ambient temperature in the storage area should not exceed the range of -50°C to
+80°C.
10. QUALITY
ACCEPTANCE TEST PROTOCOL
Prior to shipment to customers, all NOCTURN XL cameras are tested according to PHOTONIS
Acceptance Test Protocol (ATP). The ATP verifies that the camera units meet the operating,
functionality and imaging characteristics specified by PHOTONIS. Every unit is shipped with a test
sheet displaying these characteristics against the NOCTURN XL specifications.
WARRANTY
Unless otherwise agreed, the Seller shall at its option repair or replace or refund the price paid for,
those Nocturn XL Cameras which are proved to the Seller's reasonable satisfaction not to conform to
the published specifications at the time of receipt by the Buyer or to have failed for any reason of faulty
design, material or workmanship for a period of twelve (12) months following the date of delivery.
Such warranty does not apply: (i) if the product has been modified or altered in any way by parties other
than PHOTONIS, (ii) iif the product has been exposed to unusual or excessive environmental,
mechanical, electrical, or thermal stress during the course of installation or use, or (iii) if the absolute
maximum ratings are exceeded for any reason including, but not limited to, equipment design and
improper device installation or application, or (iv) if product malfunction is the result of misuse, abuse,
improper installation or application, alteration, accident, or negligence in use, storage, transportation or
handling, or if the original identification markings on the product have been removed, defaced or
altered.
In order to permit PHOTONIS to properly administer this warranty, Buyer shall (i) notify PHOTONIS
promptly in writing of any claims, and (ii) provide PHOTONIS with the opportunity to inspect and test
To Next Page
Loading...
