Physio Control LIFEPAK 9 - Page 200

LIFEPAK
9
defibrillator/monitor
Parts Lists, Explanation of, 5-1
Parts, How to Order, 5-2
PARTSLINE Telephone Number, 5-2
Patient Cable Connector, 2-5
PCB Repair, Precautions, 4-15
Performance
Inspection
Procedure
(PIP).
See
PIP
Physical Description, 1-1
PIP (Performance Inspection Procedure), 3-1
1mV CAL, 3-9
AC Power, 3-4
Battery Charge (BATT CHRG) Check, 3-5
Battery Power, 3-5
Charge Reduction, 3-13
Charge Time, 3-12
Checklist, 3-18
CODE SUMMARY, 3-14
CRT Gain/Aspect Ratio, 3-9
Defib Disarm and CHARGE LEDs Check, 3-12
Definitions, 3-2
Delivered Energy, 3-14
Discharge Control, 3-13
ECG Display, 3-8
Energy Dump, 3-13
General Instructions, 3-4
Heart Rate, 3-9
Keypad Test, 3-7
Lead Select, 3-8
Leakage Current, 3-16
Paddle Polarity, 3-12
Personnel Training Requirements, 3-3
Physical Inspection, 3-4
Purpose, 3-1
Rate Alarms/Alarm-Activated Record, 3-10
Recorder Annotation/Real-Time Clock, 3-10
Recorder Speed/Baseline Centering, 3-8
Recorder/CRT Noise, 3-11
Required Test Equipment, 3-2
Requirements, 3-2
Scope and Applicability, 3-2
Setup Menu Settings, 3-5
Sync/Sync Annotation, 3-11
Test Equipment Required, 3-2
Test Load, 3-10
Test Setup, 3-5
Workstation Requirements, 3-3
Power Control Circuit, 1-9
Power Conversion PCB Assembly, 1-9
Disassembly, 4-10
Parts List, 5-34
PCB Layout, 5-41
Index-4
All Rights Reserved
Schematic, 5-42
Theory of Operation, 1-9
Voltage Checks (TCP Test), 3-23
Power Supply PCB Assembly, 1-8
Calibration (TCP), 3-33
Disassembly, 4-11
Parts List, 5-29
PCB Layout, 5-32
Schematic, 5-33
Theory of Operation, 1-8
Power-On Circuit, 1-8
Preamp, Pulse Widths, 1-21
Preamp Circuit, 1-19
Printer. See Strip Chart Recorder
Printhead Control Circuit, 1-30
Printhead Resistance Evaluation Circuit, 1-32
Program EPROM Circuit, 1-29
Program RAM Circuit, 1-29
Publication Dates, Effective, xvi
Q
QRS Indicator, 2-4
QRS VOL Pushbutton, 2-6
R
Raster Generator Circuit, 1-35
Raster Scan Oscillator Circuit, 1-34
Raster Voltage Generator Circuit, 1-34
Rear Panel Membrane Switch, 5-51
PCB Layout, 5-51
Schematic, 5-51
Recharging Batteries, 4-1
RECORD Pushbutton, 2-3
Recorder
See also Strip Chart Recorder
Brief description, 2-5
Recorder Calibration, 3-34
Recorder Frequency Response test (TCP), 3-36
Recorder Power Circuit, 1-30
Recycling Batteries, 4-4
Reference Designator Key, 5-4
Regulation Circuit, 1-8
Removal and Replacement of Assemblies. See
Disassembly Procedures
Repair and Cleaning, Tools and Materials for, 4-13
Replacement Parts, How to Order, 5-2
© August 1993 Physio-Control