Physio Control LIFEPAK 9 - Page 201

S
Safety
General Information, xii
Symbols, xiv
Terms, xii
Schematic Diagram
Defibrillation Adapter, 5-86
Display PCB/CRT (Monitor PCB), 5-66
Explanation of, 5-2
Interconnect PCB, 5-48
Keypad Assembly, 5-50
Main PCB, 5-25
Paddle Assembly, 5-56
Power Conversion PCB, 5-42
Power Supply PCB, 5-33
Rear Panel Membrane Switch, 5-51
Sense Leads PCB (Mounted on Power Conversion
PCB), 5-42
Strip Chart Recorder, 5-54
Transfer Relay Assembly, 5-55
Sense Leads PCB (on Power Conversion PCB)
PCB Layout, 5-41
Schematic, 5-42
Serial Data Interface Circuit, 1-15
Service and Maintenance Information, 4-1
SERVICE Indicator and Error Codes
Error Codes, 3-40
How to Clear, 3-40
Status Message Display, 2-4
Service Information Overview, xv
SET Pushbutton. See Setting the Clock
Setting the Clock, 2-10
Setup Menu
Access, 2-8
Settings for PIP, 3-5
Specifications, 1-3
SSD (Static Sensitive Devices)
Proper Storage, 4-6
Special Handling of, 4-5
Static-Dissipative Mat, 4-6
Static-Free Work Area, 4-6
Symbol, 4-5
Work Area, 4-6
Wrist Strap, 4-6
Static Sensitive Devices. See SSD
Status Message Display, 2-4
STERNUM Paddle Description, 2-5
Storage or Shipping, 4-16
© August 1993 Physio—Control
All Rights Reserved
Index
Strip Chart Recorder
Assembly Drawing, 5-53
Cleaning, 4-5
Disassembly Procedure, 4-8
Loading Paper, 4-4
Maintenance, 4-4
Parts List, 5-52
Protecting Printouts, 4-5
Recorder Calibration (TCP), 3-34
Recorder Frequency Response Test (TCP), 3-36
Schematic, 5-54
Supplies and Accessories, 5-5
Switching Power Supply Circuit, 1-11
Symbols
Explanation of, xiv
Used in Manual or on Equipment, xiv
SYNC Pushbutton, 2-3
System Clock Circuit, 1-26
System Controller Circuit, 1-24
T
TCP. See Test and Calibration Procedure
Terms, Definition of, xii
Test and Calibration Procedure (TCP), 3-20
Charge Time, 3-28
Checklist, 3-39
CRT Frequency Response, 3-38
Defibrillator Calibration, 3-25
Defibrillator Charge Time, 3-28
Definitions, 3-20
Display Calibration, 3~29
ECG Output, 3-38
Low Battery Threshold Checks, 3-23
Output Waveform, 3-28
Personnel Training Requirements, 3-21
Power Supply Calibration, 3-33
Purpose, 3-20
Recorder Calibration, 3-34
Recorder Frequency Response, 3-36
Requirements, 3-20
Scope, 3-20
Test Equipment Required, 3-21
Test Load Calibration, 3-27
Test Menu Access, 3-25
Voltage Checks, 3-22
Workstation Requirements, 3-21
Test Equipment Required
PIP, 3-2
Test and Calibration, 3-21
Test Load, 2-5
Test Load Calibration (TCP), 3-27
Index-5