Physio Control LIFEPAK 9 - Page 53

LIFEPAK 9 defibrillator/monitor
2-6
CAUTION ELECTRICAL SHOCK CAUTION DISCONNECT POWER
HAZARD. DO NOT REMOVE COVER. BEFORE CHANGING FUSES.
REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.
©
4A 250 SLOW BLOW FUSES
WARNING RISK OF FIRE
REPLACE FUSES AS MARKED
©
Figure 2-2 Rear Panel Controls, Indicators, and Connectors
Table 2-2 Rear Panel Controls, Indicators, and Connectors
Item Function
1 TIME/DATE Pushbuttons for setting the real-time clock.
MODE Pressing once selects the clock setting mode. Pressing repeatedly
selects minutes, hour, year, month, day fields. Pressing again exits the
clock setting mode.
SET Pressing advances the value displayed in the selected clock set field.
2 W ORSVOLA Pressing the up or down scroll pushbutton increases or decreases the
ORS volume. The last setting is retained when power is off.
3 1mV CAL Pressing displays a ImV calibration signal on the CRT and recorder.
4 Ground Eguipotential ground tie point.
5 ECG OUTPUT ECG out connector; 1V/mV output with ECG gain of 1 (press
ECG SIZE to set gain).
6 AC Power Connector AC power connector.
7 Fuse Cover Access panel for changing fuses.
8 Mains Power Rocker switch turns ac line power on (I) or off (0). On some models a
clip is installed which locks this switch in the on position.
All Rights Reserved © August 1993 Physio-Control