Physio Control LIFEPAK 9 - Page 61

LIFEPAK 9 defibrillator/monitor
Warning POSSIBLE ARCING AND PADDLE DAMAGE. When discharging the
defibrillator into the internal test load, make sure the standard paddles are
securely and properly stored in the paddle storage area (STERNUM paddle
on the left, APEX paddle on the right). This helps prevent arcing and
formation of pits on paddle electrode surfaces. Pitted or damaged paddle
electrode surfaces can cause patient skin burns during defibrillation.
PIP-General Instructions The following sections are the actual PIP steps to be performed. These steps
are designed to be executed in sequential order. For instance, if a heart rate
input of 30bpm is specified for one test it also applies to the next test unless
you are instructed to change it.
PIP-Physical Inspection Before beginning the PIP-Physical Inspection, be sure to disconnect the ac
power cord from the ac power source.
e Inspect all exterior surfaces for signs of abuse or other damage,
including fluid spills, cracks and dents.
e Inspect paddles for pitted electrode plates, presence of dried
defibrillation gel, and integrity of cables and switches. Remove gel or
other foreign matter from paddles and paddle wells.
e Inspect recorder for ease of door operation and positive latching.
Remove dust or foreign matter inside recorder.
e Inspect all external connections for bent, broken, or corroded pins, and
debris.
e Inspect the power cord and all cables and accessories for damage,
cracks, breaks, bent or broken connector pins, or other signs of wear.
e Open the battery door on the bottom of the defibrillator/monitor and
make sure batteries are installed. Close the door and make sure it
latches properly.
e © Press the ON pushbutton and confirm that the green LED illuminates.
Press ON again and make sure the green LED is off and power is off (the
display is blank). Then press all other pushbuttons and check them for
uniform mechanical resistance.
PIP-AC Power 1. Connect the defibrillator/monitor to ac power.
2. Ifthe dash number of the defibrillator/monitor is listed below, confirm
that the power module clip is installed at the bottom of the rear panel
power switch, locking the switch to the power on (I) position. Then go
on
to step 3.
Dash Numbers with Power Module Clip Installed
803800-09 803800-300
803800- 18 803800-309 thru -312
803800-28 803800-314 thru -316
170008-000 A
3-4 All Rights Reserved O August 1993 Physio—Quntrol