PI MS249E - Page 214

8 GCS Commands
208 Version: 1.2.1 MS249E C-863.12 Mercury Controller
17
PI_CNTR_PARAM_OUT_OF_RANGE
Parameter out of range
18
PI_CNTR_INVALID_MACRO_NAME
Invalid macro name
19
PI_CNTR_MACRO_RECORD
Error while recording macro
20
PI_CNTR_MACRO_NOT_FOUND
Macro not found
21
PI_CNTR_AXIS_HAS_NO_BRAKE
Axis has no brake
22
PI_CNTR_DOUBLE_AXIS
Axis identifier specified more
than once
23
PI_CNTR_ILLEGAL_AXIS
Illegal axis
24
PI_CNTR_PARAM_NR
Incorrect number of
parameters
25
PI_CNTR_INVALID_REAL_NR
Invalid floating point number
26
PI_CNTR_MISSING_PARAM
Parameter missing
27
PI_CNTR_SOFT_LIMIT_OUT_OF_RANGE
Soft limit out of range
28
PI_CNTR_NO_MANUAL_PAD
No manual pad found
29
PI_CNTR_NO_JUMP
No more step-response
values
30
PI_CNTR_INVALID_JUMP
No step-response values
recorded
31
PI_CNTR_AXIS_HAS_NO_REFERENCE
Axis has no reference sensor
32
PI_CNTR_STAGE_HAS_NO_LIM_SWITCH
Axis has no limit switch
33
PI_CNTR_NO_RELAY_CARD
No relay card installed
34
PI_CNTR_CMD_NOT_ALLOWED_FOR_STA
GE
Command not allowed for
selected stage(s)
35
PI_CNTR_NO_DIGITAL_INPUT
No digital input installed
36
PI_CNTR_NO_DIGITAL_OUTPUT
No digital output configured
37
PI_CNTR_NO_MCM
No more MCM responses
38
PI_CNTR_INVALID_MCM
No MCM values recorded
39
PI_CNTR_INVALID_CNTR_NUMBER
Controller number invalid
40
PI_CNTR_NO_JOYSTICK_CONNECTED
No joystick configured
41
PI_CNTR_INVALID_EGE_AXIS
Invalid axis for electronic
gearing, axis can not be slave
42
PI_CNTR_SLAVE_POSITION_OUT_OF_RAN
GE
Position of slave axis is out of
range
43
PI_CNTR_COMMAND_EGE_SLAVE
Slave axis cannot be
commanded directly when
electronic gearing is enabled
44
PI_CNTR_JOYSTICK_CALIBRATION_FAILED
Calibration of joystick failed
45
PI_CNTR_REFERENCING_FAILED
Referencing failed
46
PI_CNTR_OPM_MISSING
OPM (Optical Power Meter)
missing