PI MS249E - Page 215

8 GCS Commands
C-863.12 Mercury Controller MS249E Version: 1.2.1 209
47
PI_CNTR_OPM_NOT_INITIALIZED
OPM (Optical Power Meter)
not initialized or cannot be
initialized
48
PI_CNTR_OPM_COM_ERROR
OPM (Optical Power Meter)
Communication Error
49
PI_CNTR_MOVE_TO_LIMIT_SWITCH_FAILE
D
Move to limit switch failed
50
PI_CNTR_REF_WITH_REF_DISABLED
Attempt to reference axis
with referencing disabled
51
PI_CNTR_AXIS_UNDER_JOYSTICK_CONTRO
L
Selected axis is controlled by
joystick
52
PI_CNTR_COMMUNICATION_ERROR
Controller detected
communication error
53
PI_CNTR_DYNAMIC_MOVE_IN_PROCESS
MOV! motion still in progress
54
PI_CNTR_UNKNOWN_PARAMETER
Unknown parameter
55
PI_CNTR_NO_REP_RECORDED
No commands were recorded
with REP
56
PI_CNTR_INVALID_PASSWORD
Password invalid
57
PI_CNTR_INVALID_RECORDER_CHAN
Data Record Table does not
exist
58
PI_CNTR_INVALID_RECORDER_SRC_OPT
Source does not exist;
number too low or too high
59
PI_CNTR_INVALID_RECORDER_SRC_CHAN
Source Record Table number
too low or too high
60
PI_CNTR_PARAM_PROTECTION
Protected Param: current
Command Level (CCL) too low
61
PI_CNTR_AUTOZERO_RUNNING
Command execution not
possible while Autozero is
running
62
PI_CNTR_NO_LINEAR_AXIS
Autozero requires at least one
linear axis
63
PI_CNTR_INIT_RUNNING
Initialization still in progress
64
PI_CNTR_READ_ONLY_PARAMETER
Parameter is read-only
65
PI_CNTR_PAM_NOT_FOUND
Parameter not found in non-
volatile memory
66
PI_CNTR_VOL_OUT_OF_LIMITS
Voltage out of limits
67
PI_CNTR_WAVE_TOO_LARGE
Not enough memory available
for requested wave curve
68
PI_CNTR_NOT_ENOUGH_DDL_MEMORY
Not enough memory available
for DDL table; DDL can not be
started
69
PI_CNTR_DDL_TIME_DELAY_TOO_LARGE
Time delay larger than DDL
table; DDL can not be started