PI MS249E - Page 231

8 GCS Commands
C-863.12 Mercury Controller MS249E Version: 1.2.1 225
host PC
-1052
PI_FILE_TRANSFER_CRC_ERROR
Checksum error when
transferring a file to/from the
controller
-1053
PI_COULDNT_FIND_PISTAGES_DAT
The PiStages.dat database
could not be found. This file is
required to connect a stage
with the CST command
-1054
PI_NO_WAVE_RUNNING
No wave being output to
specified axis
-1055
PI_INVALID_PASSWORD
Invalid password
-1056
PI_OPM_COM_ERROR
Error during communication
with OPM (Optical Power
Meter), maybe no OPM
connected
-1057
PI_WAVE_EDITOR_WRONG_PARAMNUM
WaveEditor: Error during
wave creation, incorrect
number of parameters
-1058
PI_WAVE_EDITOR_FREQUENCY_OUT_OF_
RANGE
WaveEditor: Frequency out of
range
-1059
PI_WAVE_EDITOR_WRONG_IP_VALUE
WaveEditor: Error during
wave creation, incorrect index
for integer parameter
-1060
PI_WAVE_EDITOR_WRONG_DP_VALUE
WaveEditor: Error during
wave creation, incorrect index
for floating point parameter
-1061
PI_WAVE_EDITOR_WRONG_ITEM_VALUE
WaveEditor: Error during
wave creation, could not
calculate value
-1062
PI_WAVE_EDITOR_MISSING_GRAPH_COM
PONENT
WaveEditor: Graph display
component not installed
-1063
PI_EXT_PROFILE_UNALLOWED_CMD
User profile mode: command
is not allowed, check for
required preparatory
commands
-1064
PI_EXT_PROFILE_EXPECTING_MOTION_ER
ROR
User profile mode: first target
position in user profile is too
far from current position
-1065
PI_EXT_PROFILE_ACTIVE
Controller is (already) in user
profile mode
-1066
PI_EXT_PROFILE_INDEX_OUT_OF_RANGE
User profile mode: block or
data set index out of allowed
range
-1067
PI_PROFILE_GENERATOR_NO_PROFILE
ProfileGenerator: No profile
has been created yet