Check that the oil holes on the pumping element
are not clogged. - Check that the O-ring shows no
sign of damage.
- Insert a new oil guard with the special adaptor
handle and take it to the stop.
- Insert the safety clip.
- Insert a new dust guard.
- Insert the contrast spring into the pumping mem-
ber.
- Insert the pumping element inside the stem.
- Insert the pumping element guide bushing at the
lower stem end.
- Insert the stem in the leg being careful not to let
the stem guide bushing come out.
- Inset and screw up the copper washer to the pre-
scribed torque. To avoid the rotation of the pump-
ing element insert a 12 mm hexagonal wrench on
the stem for internals. - Put 125 ± 1 cc of oil in the
stem.
Recommended products
AGIP FORK 7.5 W Fork oil
Grade 7.5 W
Suspensions Runner 125 - 200
SUSP - 226
To Next Page
Loading...
