© 2020 Pierce Manufacturing Inc. All Rights Reserved. Towing / 6-35
MAINTENANCE
6-25.7 Tire Lift Method (Preferred)
IMPORTANT: Tire lift attachment should have a minimum capacity rating of 25,000 lbs.
Figure 6-8: Underlift Device using Tire Lift Brackets
1253
On trucks equipped with TAK-4™ independent front suspension, lift the front of the disabled vehicle using an
underlift device with proper tire lift brackets that support and secure the front tires (Figure 6-8). Do not lift the front
of the disabled vehicle by attaching to or lifting by any component or structure of the TAK-4™ suspension.
Special precautions are necessary when using the tire lift method on a TAK-4 T3 equipped truck in
order to prevent damage to the steering system. See “TAK-4® T3 Rear Steering Axle Towing” on
page 6-33.
A typical Pierce Custom Chassis can be towed using an 138 inch underlift reach. Aerial Platforms
should be towed with at least an 177 inch underlift reach. Ensure there will be enough clearance
between the towing vehicle and components on the disabled vehicle to turn while being towed. Failure
to comply may result in damage to equipment.
To Next Page
Loading...
