GENERAL
4-2 / Safe Vehicle Entry and Exit
© 2020 Pierce Manufacturing Inc. All Rights Reserved.
Secure the vehicle in a safe, dry location before working on the vehicle. Use an overhead safety harness, fall arrest
harness, step ladder, access platform, personal protective equipment, or other means to keep safe while working
on the vehicle. If there is no slip resistant surface, use rubber matting or other means to provide traction before
attempting to step, stand, or walk on these areas.
4-1.4 No-Step Surfaces
Slip resistant surfaces are present where operators will normally need to step, stand, or walk on the vehicle.
Use caution on surfaces that do NOT have slip resistant surfaces and/or do not have railings. These areas are not
intended for standing or walking during normal operation.
• If you must step, stand, or walk on these surfaces, use rubber matting or other ways to provide traction on the
surface.
4-1.5 Do Not Occupy With Vehicle in Motion
This vehicle may have an area that is meant to be occupied with the vehicle in a stationary condition only. This
restriction may be due to the fact that there are no seats equipped with seat belts. Other reasons for restriction may
be that there are un-mounted seats or other equipment that could come loose during a crash. Do not place the
vehicle in motion with any person occupying this area.
4-2. Keyless Entry (Optional)
4-2.1 To Unlock Officer’s Door
• Enter access code
• Listen for double beep
• Within three seconds, press the (1/2) button
4-2.2 To Unlock All Doors
• Enter access code
• Listen for double beep
• Within three seconds, press the (3/4) button
Fall Hazard - Railings NOT provided
Surface may be slippery - NOT intended for stepping, standing or walking.
Fall will injure or kill.
Crash Hazard.
Do not occupy with vehicle in motion.
Failure to comply may result in injury or death.
To Next Page
Loading...