Safety
Operating Manual PNOZ m1p (ETH)
20878-EN-16
12
3.3.2 Use of qualified personnel
The products may only be assembled, installed, programmed, commissioned, operated,
maintained and decommissioned by competent persons.
A competent person is a qualified and knowledgeable person who, because of their train-
ing, experience and current professional activity, has the specialist knowledge required. To
be able to inspect, assess and operate devices, systems and machines, the person has to
be informed of the state of the art and the applicable national, European and international
laws, directives and standards.
It is the company’s responsibility only to employ personnel who
} Are familiar with the basic regulations concerning health and safety / accident preven-
tion,
} Have read and understood the information provided in the section entitled Safety
} Have a good knowledge of the generic and specialist standards applicable to the spe-
cific application.
3.3.3 Warranty and liability
All claims to warranty and liability will be rendered invalid if
} The product was used contrary to the purpose for which it is intended,
} Damage can be attributed to not having followed the guidelines in the manual,
} Operating personnel are not suitably qualified,
} Any type of modification has been made (e.g. exchanging components on the PCB
boards, soldering work etc.).
3.3.4 Disposal
} In safety-related applications, please comply with the mission time T
M
in the safety-re-
lated characteristic data.
} When decommissioning, please comply with local regulations regarding the disposal of
electronic devices (e.g. Electrical and Electronic Equipment Act).
3.3.5 For your safety
The device meets all the necessary conditions for safe operation. However, you should al-
ways ensure that the following safety requirements are met:
} This operating manual only describes the basic functions of the device. Advanced func-
tions are described in the online help for the PNOZmulti Configurator, in the
"PNOZmulti Communication Interfaces" document and in "PNOZmulti Special Applica-
tions". Only use these functions once you have read and understood the documenta-
tion.
} You must note the information stated in the PNOZmulti Safety Manual.
} Adequate protection must be provided for all inductive consumers.
} Do not open the housing or make any unauthorised modifications.
} Please make sure you shut down the supply voltage when performing maintenance
work (e.g. exchanging contactors).
To Next Page
Loading...
Need help?
General
