Contents
Operating Manual PNOZ m1p (ETH)
20878-EN-16
3
Section 1 Introduction 5
1.1 Validity of documentation 5
1.2 Using the documentation 5
1.3 Definition of symbols 5
Section 2 Overview 7
2.1 Range 7
2.2 Unit features 7
2.3 Chip card 8
2.4 Front view 9
Section 3 Safety 11
3.1 Intended use 11
3.2 System requirements 11
3.3 Safety regulations 11
3.3.1 Safety assessment 11
3.3.2 Use of qualified personnel 12
3.3.3 Warranty and liability 12
3.3.4 Disposal 12
3.3.5 For your safety 12
Section 4 Function description 13
4.1 Integrated protection mechanisms 13
4.2 Functions 13
4.3 Block diagram 13
4.4 Diagnostics 14
4.5 Cascading 14
4.6 Safety mat, muting 14
4.7 Interfaces 14
Section 5 Installation 15
5.1 Control cabinet installation 15
5.2 Dimensions 16
5.3 Install base unit without expansion module 16
5.4 Connecting the base unit and expansion modules 17
Section 6 Commissioning 18
6.1 General wiring guidelines 18
6.2 Ethernet interfaces (ETH version only) 19
6.2.1 RJ45 interfaces ("Ethernet") 19
6.2.2 Requirements of the connection cable and connector 19
6.2.3 Interface configuration 19
6.2.4 RJ45 connection cable 20
6.2.5 Process data exchange 21
6.3 Function test during commissioning 21
6.4 Commissioning the PNOZmulti control system for the first time 22
6.4.1 Load project from chip card 22
To Next Page
Loading...
Need help?
General
