Pima Hunter-Pro 832 - Key #1: Arming and Disarming the System; System Arming Procedures; Keypad Arming Process; Exit and Entry Delayed Zones Explained

Key #1: Arm & Disarm
9
2. Key #1: Arm & Disarm
To arm and disarm your alarm system, enter the Master or the Short codes and press ‘1’. Users
should only enter their code to arm and disarm.
If no zone is open and no fault exists, the Exit delay countdown starts, the keypad buzzer sounds
beeps and the green ARMED LED flashes. You can now exit the premises and close the door
behind you
1
.
When the Exit delay ends, the system becomes armed: the green ARMED LED stops to flash and
stays on, the beeps stop, the message “System Armed” is briefly displayed and then the date and
time are displayed.
2.1 Arm
Your alarm system can be armed in the following ways:
1. Via the keypad.
2. Automatically, at a preset time. See section 10, on page 26.
3. By a key fob, key switch, RFID tag/keychain, and remote control (Hunter-Pro only). See
section 12.2, on page 30.
4. Remotely, by the phone (Hunter-Pro only). See section 13, on page 34.
2.1.1 Via the keypad
 Master or Short code  OR, with an authorized user code: 
  authorized user code  ...
2.1.2 Exit & entry delayed zones
To arm the alarm system all zones should be closed, except those on the exit route. Alarming or
faulty zones must be reinstated before you can arm the system. Open zones are indicated by a
rectangle _ (on ‘Fast zone’ display mode) or ‘OP’ (on ‘Scan open zones’ display mode).
Zones such as exit doors and areas near the keypad can be programmed not to trigger the alarm
for a limited time, while the system is arming and you leave or enter the premises.
The Exit and Entry delay times are programmed by the installer. The installer can also set two
different Entry delays, to two different entry paths, for example.
2.1.3 Fast arming to Full mode
2
 until the Exit delay starts running -OR-
 Short code ...
For instructions on how to set the Short code, refer to section 9.4, on page 25. For fast arming to
the ‘Home’ modes, refer to section 5, on page 14.
1
The Exit delay can start immediately as soon as the final door is closed. Refer to the Installer.
2
Fast arming must be enabled by the Installer.
1
1
Arming...
Exit Delay 60
System Armed!
1
Arming...
Exit Delay 60
System Armed!