Introduction
7
1.6 System codes
1.6.1 Master code
The Master code is a super user code with all the access authorizations. It is mainly used for
changing the “Master Code” itself and for remote connection.
The default factory Master Code is 5555.
Replace the default Master code immediately after installation to prevent
unauthorized and illegal operations.
1.6.2 User codes
A User code allows you to grant the user access authorizations, disarming time frame and more. It
is reported and logged together with any action the user is taking.
Users can be restricted from parts of the user menu by the user authorizations.
1.6.3 Short Code
A 2-numeral code, used only for arming.
1.6.4 Duress Code
A code for using in distress situations. When you are forced to disarm the alarm system, enter this
code that disarms the system, but also sends a silent alarm to the Monitoring Station (where
relevant) and your phone.
1.7 The User menu
The User menu is where parameters such as time & date, user codes and user authorizations are
set. To access the User menu, do one of the following:
Enter the Master code:
Master code OR
Press and hold ‘0’ for 2 sec. and enter an authorized user code:
authorized user code .
See section 9.2.4, on page 22 on how to restrict users from accessing the User menu.
By default, entering a User code arms or disarms the alarm system (toggle mode). The Installer
can program the system, so entering the code displays the User menu.
After entering the User menu, the sub-menus are accessed directly, by pressing the keypad keys.
Each key menu is printed above it, e.g. “Time”, “Codes”.
To Next Page
Loading...
