Pima Hunter-Pro 832 - Remote Phone Control (Hunter-Pro Only); Basic Remote Control Mode

Hunter-Pro Series & Captain 8 User Guide
34
13. Remote Control via the phone
(Hunter-Pro Only)
The Hunter-Pro Series alarm system can be remotely controlled via any touchtone or cellular
phone. A remote control call can be initiated by both calling the panel and receiving a call from
the panel.
There are two modes to remote control (set by the Installer):
 Basic mode: includes arming, disarming, deactivating the sirens, and more. That is
the default mode.
 Full mode: includes the basic mode and in addition, activating relay switches.
13.1 Basic mode
To control the alarm system remotely:
1. Call the phone number to which the alarm system is connected (or answer a call from it).
2. Wait for a confirmation tone: a long tone followed by 2 beeps.
The system does not recognize phone commands (tones) while sounding
the confirmation tone. Therefore, you must wait until the confirmation tone
is over, before pressing any phone key.
3. Dial the Master code (or an authorized User code. see section 9.2.4, on page 22).
4. Wait for a status tone:
Continuous: The system is disarmed.
Beeps: The system is armed.
5. Dial a number, according to the next table. The system confirms every command with 2 beeps.
Dial
Action
0
Deactivate the external siren and the phone dialer
1
Arm to Full mode
2
Disarm (must be enabled by the Installer)
4
Arm to ‘Home 1’ mode
5
Switch on the relay
6
Switch off the relay
7
Arm to ‘Home 2’ mode
8
Listen-in for one minute
13
. Press more to extend by one minute
13
By the MIC-200 microphone.