Pima Hunter-Pro 832 - Scanning Open Zones; Disabling Zone Status Display; Alternative Display Types

Hunter-Pro Series & Captain 8 User Guide
16
Char.
Description
B
The zone is bypassed
C
Chime zone
F
The zone is at fault (or a tamper switch is open). Call service immediately!
L
Low battery in a wireless detector
O
24-hour zone is open or, armed partition (with its no. below). Press to
display the armed partitions.
S
Short in the zone's wires
T
The zone is in soak (test) mode
V
A wireless detector is not responding
6.2 Scan open zones
Master code   
In this option, the system continuously scans the zones and the system’s status, and displays open
zones, faults and alarms by different characters. The information is scrolled on the display.
For example:
The zones’ status indicators are:
Char.
Description
OP
Open
AL
Alarm - currently or when the system was armed.
FL
Cut
SH
Short
SV
Supervision loss
LB
Low battery (wireless zone)
AM
Anti-mask
6.3 Disable zone displaying
Master code   X2 
The zones’ status is not displayed, only alarms and faults (if there are any).
6.4 Other types
The other types are used for displaying various information. On each type, after you press
its information is displayed for a minute. See the menu screens on section 5.1, on page Error!
Bookmark not defined..
#
5
NEXT
Display Type:
Scan Open Zones
ENTR
5
NEXT
Display Type:
Disable Zn. Disp
ENTR
ENTR