Pioneer PDP-433CMX Service Manual

117
PDP-433CMX
5
678
5
6
7
8
C
D
F
A
B
E
GAS (Get Adjust Slot): Outputting data related to the picture quality setting
• Data are output according to the transmission order and size in the table below.
• Data for the SLOT section of the Factory menu are output.
• This command is invalid when the current input function is one other than VIDEO input of the SLOT system.
• This command is invalid when no SLOT is connected or when a SLOT from another vendor is connected.
• This command is invalid in modes other than RS-232C Factory Adjustment mode.
Data Power-Down Point
0 None
1 Y-DRIVE
2 Y-DC/DC CONVERTER
3 X-DC/DC CONVERTER
4 X-DRIVE
5 Power supply
6 ADDRESS junction
7 ADDRESS resonance
8 DC/DC CONVERTER (DIGITAL)
Order Data Contents Size Remarks
1
Y-DELAY
(Reference data) 3 byte
2 (Offset data) 3 byte (Note 1)
3
Y-OUT LEVEL
(Reference data) 3 byte
4 (Offset data) 3 byte (Note 1)
5
CD TINT
(Reference data) 3 byte
6 (Offset data) 3 byte (Note 1)
7
CDR OFFSET
(Reference data) 3 byte
8 (Offset data) 3 byte (Note 1)
9
CDB OFFSET
(Reference data) 3 byte
10 (Offset data) 3 byte (Note 1)
11
R-Y LEVEL
(Reference data) 3 byte
12 (Offset data) 3 byte (Note 1)
13
B-Y LEVEL
(Reference data) 3 byte
14 (Offset data) 3 byte (Note 1)
(Note 1) : If data are output when Reference mode is selected, the same data as the reference data are output as the offset data.
(∗) See the table below on contents of PD information.

Pioneer PDP-433CMX Specifications

General

Brand	Pioneer
Model	PDP-433CMX
Category	Monitor
Language	English