Orlthisunitthereare4inputsystems,TherearealsoCONTROLterminalsforconnectionofPIONEERcomponentswith
the_l markFordetailsregardingaspecificconnectionformat,refertothepagewritteninparenthesis
Bottom view
_N OtJ_ IAC_O_¥ AL_JLJ_IMC NI ANALOG
CON Tr_{)l I _4_MINA_ R G B
_NPLJT4
_1_CONTROL IN/OUT
For connection of PIONEER components that bear the
mark, Making CONTROL connection enables
control of this unit as a component in a system
(page 15),
_2) FACTORY ADJUSTMENT TERMINAL
DO NOT MAKE ANY CONNECTIONS TO THIS
TERMINAL,
This te_rninal is used in the facto W setup,
_3_INPUT4
For connection of a personal computer (PC) or similar
component, Make sure that the connection made
corresponds to the format of the signal output from
the connected component (pages 11 to 13)
_4_INPUT3
For connection of components that have RGB or
component output jacks such as a personal compute_,
DVD player, or external RGB decedel (pages 11 to 13),
_5_Synchronizing signal impedance selector switch
Depending on the connections made at INPUT3, it
may be necessa W to set this switch to match the
output impedance of the connected component's
synchronization signal
When the output impedance of the component's
synchronization signal is above 75 _, set this switch
to the 2,2 k_ position (pages 12 and 13),
_ INPUT2
For connection of DVD player with component video
output (page 10)
_ INPUT1
Fo_connection of components that have an S-video or
composite video output jack such as a video deck,
video camera, laser disc player, or DVD playel (page 10),
Note: It is possible to have connections made to both
the VIDEO and S-VIDEO jacks at the same time
However, if simultaneous signals a_e _eceived, the
S-video signal is given priority (page 10)
_ AC INLET
Use to connect the supplied powe_ cord to an AC
outlet (page 15)
<ARE1"/49 > En
To Next Page
Loading...
