Adjusting the screen
Adjust when INPUT2, INPUT3 or INPUT4 is selected,
(Adjustments on this page cannot be made when INPUT
1 is selected)
The SCREEN adjustment screen provides the adjustment
items listed in the right column
2,3,4,5
1 Press MENU to display the menu screen.
The menu screen appears
2 Press A/V to select SCREEN, then press
SET/SELEC_
3 Press A/V to select OTHER, then press
SET/SELECT.
When viewing an image from a persona[ computeh
the following screen is displayed.
4 Press A/V to select the adjustment item, then
press SET/SELECT.
5 Press <1/I_ to carry out the adjustment.
Use A/V for the adjustments of V,POS[T[ON,
After selecting, press SET/SELECT to enter your
selection
6 When adjustment is finished, press MENU to exit
the menu screen.
Note
Make these adjustmonts for each input (INPUT2to INFUT4) and
for each signal (pages55 and 56)
SCREEN mode adjustment items
Below are brief descriptions of the options that can be set
[n the SCREEN mode,
H POSITION ............ Adjust the picture's position to the
left or right,
V POSITION ............. Adjust the picture's position upward
or downward,
CLK FREQ ............... Adjust letter breakup or noise on the
screen This setting adjusts the
unit's internal clock signal flequency
that corresponds to the input video
signal
CLK PHASE ............. Adjust so that there is minimum
flicker of screen letters or color
misalignment This setting adjusts
the phase of the internal clock signal
adjusted by the CLK FREQ setting,
Notes
• When INPUT1 is se[octed, OTHER cannot be selected
• V POSITION adjustment when the screen size is set to ZOOM
or CINEMA WIDE cannot be performed as shown in the menu
screen in step 3 7o adjust the vertical position of the screen,
please follow the procedure on page 24 starting from step 2
• When CLK FREQ. adjustment is carried out, the H POSITION
setting may have to be re adjusted
• If the adjustment items in the SCREEN mode are adjusted
excessively, the picture may not be displayed properly
<ARE1349 > En
To Next Page
Loading...
