Pioneer PDP-505HD - PC Image Brightness (ABL)

Making the PC image b_ighter 4 Press A/V to select ABL, then press SET/SELECT.
Set this mode to "ON" to brighten the image during PC
signal input,
When ABL is set to "ON", the brightness of the image
will change according to changes in the input signal If
you are bothered by changes to brightness during
operation, set this mode to "OFF"
1,6
2,3,4,5
_/_2,3,4, 5
5 Press -q/_,- to select ABL setting.
If the setting is changed from "ON", it is saved to the
USER mode setting (page 30)
After selecting, press SET/SELECT to enter your
selection
6 When the setup is finished, press MENU to exit
the menu screen.
Notes
• "ON" is set when this unit is shipped from the factory
• ABL mode setting is only possible during PC signal input
1 Press MENU to display the menu screen.
The menu screen appears
2 Press A/V to select PICTURE, then press
SET/SELECT.
3 Press A/V to select OTHER, then press
SET/SELECT.