Reducing the amount of digitam
noise in the video image
(3D LEVEL)
When viewing a video image via the INPUT1 S-VIDEO
jack, it is possible to reduce the amount of digital noise in
the luminance and chromanance channels of the S-video
signal
• This setting can be adjusted along 5 points with "1 "
indicating a low level of digital noise reduction and "5"
indicating a high level of digital noise reduction,
c_ _ vo_
_ /
2,3,4,5
1 Press MENU to display the menu screen.
The menu screen appears
2 Press A/V to select PICTURE, then press
SET/SELECT.
/
3 Press A/V to select OTHER, then press
SET/SELECT.
4 Press A/V to select 3D NR LEVEL, then press
SET/SELECT.
5 Press _1/_ to set the mode to a level between 1
and 5 as needed.
If the setting is changed from "1 ", it is saved to the
USER mode setting (page 30)
After selecting, press SET/SELECT to enter your
selection
6 When the setup is finished, press MENU to exit
the menu screen.
Notes
• "1 " is set when this unit is shipped from the factory
• 3D NR LEVEL setting is possible only when INPUT1 is
selected to receive an S video signal
To Next Page
Loading...
