Moving the screen position
upward or downward
When a vista size movie etc,, is viewed at the CINEMA
WIDE or ZOOM setting, the image may net be centered
on the screen, and may extend past the edge of the
screen,
In this case, adjust the screen to an cleady viewable
position using the V POSITION setting in the SCREEN
menu,
4 Press A/V to adjust the V.POSITION setting.
Adjustable range:
e CINEMA WIDE setting :-15to15
• ZOOM setting : -25 to 25
After sdecting, press SET/SELECT to enter your
selection
5 When you have finished, press MENU to exit the
on-screen menu.
15--
Note
The V POSITION setting can be used only for signals compatible
with the screen size of CINEMA WIDE or ZOOM (NTSC, 480i or
480p)
1 Press MENU to display the menu screen.
The menu screen appears
2 Press _,/v to select SCREEN, then press
SET/SELECT.
3 Press A/V to select V.POSITION, then press
SET/SELECT.
<ARE1349 > En
To Next Page
Loading...
