To learn remote control signals
To operate odrer manufacturers' remote control signals
that cannot be p_eset using the remote control unit, have
the _emote control unit learn these signals,
LED indicator
Q
CLI GL_3U [JJ
S_EN
2,5 ll--_ ....
--1
--2
Example) ]o learn the operation to turn the VCR power
on
1 Set the mode switch to TV/VCR (first position)
when a video cassette recorder is connected.
2 Simultaneously press LEARN and number button 2.
The LED indicato_ begins blinking,
3 Press SOURCE POWER to establish the target
operation.
The LED indicato_ remains lit,
Buttons which can be learned are as follows.
VCR SOURCE POWER CH (+) CH ( ) I[ _r _r _) _r
• (VCR REC)
CABLE SOURCE POWER, CH (+), CH (), CH RETURN,
CH ENTER, 1 to 9, 0
SAT SOURCE POWER, -4, _, A, T, SET/SELECT CH (+),
CH (), (SAT)INFO
SAT MENU, SA] GUIDE, CH ENTER, 1 to 9, 0
DTV SOURCE POWER, CH (+), CH (), CH RETURN,
CH ENTER, 1 to 9, O, -(dot), GREEN, RED, YELLOW,
-4, _, A, T, SET/SELECT DVT MENU, DTV GUIDE,
DTV INFO, DTV AUDIO, CC, CLEAR, VIEW MODE
DVD SOURCE POWER, _e, _, ii, -4<1,I, i_, i_1_, 41,
m.-,A, v, SET/SELEC], DVD MENU, DVD TOP
MENU
LD SOURCE POWER, _e, i_, IIr _4_11,li, _r
4 Point the transmitters of both remote control
units toward each other with about 0.8 to 2.0 inch
(2 to 5 cm) between them, and press the POWER
button of the other manufacturer's remote control
unit,
0.8 to 2.0 inch (2 to 5 cm)
The LED indicator blinks
• If the LED indicator blinks once, return to step 3 to
learn functions for other buttons
• If the LED indicator flashes four times, it indicates
an error has occurred, Return to step 3 to redo the
learning
• If the LED indicator flashes four times even aP:er
having redone the learning, it means that the
learning capacity has reached its maximum,
5 When LEARN is pressed, the LEARN mode is
exited, and the remote control unit returns to
normal operation.
Notes
• To exit the LEARN mode dudng a learning operation, press
LEARN again
• If the mode switch position is changed while in LEARN mode,
the LEARN mode is canceled
• After steps 2 and 3, if you do not press a button for one
minute (no operation), the LEARN mode is canceled
• There are some remote control signals which cannot be
learned
To reset the LEARN setting
Have the LED blinking as in step 2 and then press and
hold the remote control unit's STANDBY/ON button
pressed for at least 2 seconds,
Note
It is necessary to reset the learn setting when you program the
remote control signal presets
• CABLE/SAT and DVD/LD cannot be selected at the same time
• (SAT) INFO has no remote control signals preset
To Next Page
Loading...
