_J GL_ELY_J
_:RE_N
-- Mode switch
®
CABLE control buttons
CABLE and SAT cannot be selected at the same time,
When the mode switch is set to CBL/SA] the cable
converter connected to this unit can be operated using
the buttons (1" to (_,
Cable converters which are made by other makers and
are not preset can also be operated using the remote
control unit if buttons (1_'to (5) have learnt the functions
(page 41),
(1) Direct channel selection buttons
Press the button (or buttons) that corresponds to the
channel that you wish to watch
(2) CH (channel) +, - buttons
Press plus (+) or minus (-) to tune in a higher or lower
channel
_._ SOURCE POWER button
Turns the power of the cable converter on and off
FL4)CH ENTER button*
Fix the selected channel with the direct channel
selection buttons
/r\
_59CH RETURN (channel return) button*
Press to switch between the current channel and the
channel you were watching immediately before
Some manufacturers do not preset ENTER and CH RETURN
Use these buttons to learn if necessary
<ARE1"/49 > En
To Next Page
Loading...
