Follow the normal safety precautions for all office equipment.
l
Please read all instructions before you attempt to operate the system. Save these instructions
for future use.
l
Use only Pitney Bowes approved supplies, in particular aerosol dusters. Improper storage and
use of aerosol dusters or flammable aerosol dusters can cause an explosive-like condition that
could result in personal injury and / or property damage. Never use aerosol dusters labelled
flammable and always read instructions and safety precautions on the duster label.
l
To obtain supplies, please contact our Supply Line™ to place orders.
l
Material Safety Data Sheets can be obtained through the web or from our Supply Line™.
l
Use the power cord supplied with the machine and plug it into a properly grounded wall outlet
located near the machine and easily accessible. Failure to properly ground the machine can
result in severe personal injury and / or fire.
l
Avoid touching moving parts or materials while the machine is in use. Keep hands, loose
clothing, jewellery and long hair away from all moving parts.
l
Do not remove covers or defeat safety interlock switches. Covers enclose hazardous parts that
should only be accessed by properly trained service personnel. Immediately report to service
any damaged or non-functioning components that renders the unit unsafe.
l
Place the unit in an accessible location to allow for proper venting of the equipment and to
facilitate servicing.
l
The power cord wall plug is the primary means of disconnecting the machine from the AC
supply.
l
If the unit becomes damaged unplug the power cord from the wall.
l
Do not use an adapter plug on the line cord or wall outlet.
l
Do not remove the ground pin from the line cord.
l
Do not use wall outlets that are controlled by wall switches and avoid sharing an outlet with other
equipment.
l
Do not route the power cord over sharp edges or trap between furniture.
l
Ensure there is no strain on the power cord and that it does not become jammed between the
equipment, walls or furniture.
l
Be certain the area in front of the wall receptacle into which the machine is plugged is free from
obstruction.
l
Before clearing a stoppage, be sure machine mechanisms come to a stop.
l
When removing stalled material, avoid using too much force to protect against minor personal
injury and damaging equipment.
l
To prevent overheating, do not cover any vent openings.
l
Operation of this equipment without periodic maintenance will inhibit optimum operating
performance and could cause the equipment to malfunction. Contact your machine supplier for
required service schedule.
l
Read all instructions before attempting to operate the equipment. Use this equipment only for its
intended purpose.
l
Always follow the specific occupational safety and health standards for your workplace.
16 • Product Information
Pitney Bowes User Guide March 2023 166
To Next Page
Loading...
