5. Click Download DeviceHub.
a. Once the download is complete, double-click the DeviceHubXX.XX.X file. This will open the
installer.
b. Click Install.
c. If prompted, enter your Mac password and click Install Software.
d. Once the installation is complete, click Close to close the installer.
e. On your computer, check the Menu bar at the top of your desktop screen and find the
DeviceHub icon. Click Yes to confirm that DeviceHub was successfully installed.
f. Click Activate DeviceHub. A new tab will open.
g. Once DeviceHub activation is successful, close the tab.
6. Click Continue PitneyShip Cube Setup.
7. Confirm your location and click Next.
Performing a test print
1. Click Print to perform a test print.
2. Tap No if the test print was unsuccessful. Then, tap Print Again. If the second test print was
unsuccessful, please contact us using the contact options.
3. Tap Yes if your test print was successful.
4. Tap Get Started. PitneyShip will now set up your experience. This could take a few minutes to
complete.
Your PitneyShip Cube setup is now complete.
Installing PitneyShip Cube on a Mac using a USB
connection (existing user)
These instructions will guide you through a first-time installation of your PitneyShip Cube on a Mac
device as an existing PitneyShip user. These instructions are for users wanting to connect their
PitneyShip Cube using a wired USB cable connection.
1. Opening the box and unpacking
2. Logging in to your PitneyShip account
3. Connecting your PitneyShip Cube
4. Performing a test print
1 • Installation
Pitney Bowes User Guide June 2023 46
To Next Page
Loading...
