EasyManua.ls Logo

Pitney Bowes PitneyShip Cube AX00 - Page 99

Pitney Bowes PitneyShip Cube AX00
101 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Important Safety and Compliance Information for
Your Printer and Scale
Product: Direct Thermal Label Printer
Model: AX00 Power Requirements: 100-240 VAC, 50/60 Hz, 1.5 A
Sound level: < 70 dba Operating Temperature: 32-104°F (0-40°C)
Agency Compliance: pitneybowes.com
Important Safety Notes
Follow the normal safety precautions for all office equipment.
n
Please read all instructions before you attempt to operate the system. Save these instructions
for future use.
n
Use only Pitney Bowes approved supplies, in particular, aerosol dusters. Improper storage and
use of aerosol dusters or flammable aerosol dusters can cause an explosive-like condition that
could result in personal injury and/or property damage. Never use aerosol dusters labeled
flammable and always read instructions and safety precautions on the duster label.
n
This printer is powered by an external AC power adapter. Use only the AC power adapter and
AC power cord supplied with the printer and plug it into a properly grounded wall outlet that's
located near the printer and easily accessible. Failure to properly ground the power adapter can
result in severe personal injury and/or fire.
n
The power cord wall plug is the primary means of disconnecting the power adapter from the AC
supply. The power adapter is on whenever it is plugged into a live receptacle.
n
Place the printer so the AC power adapter is close to an easily accessible wall outlet.
DO NOT use a wall outlet controlled by a wall switch or one that is shard with other equipment.
n
DO NOT use an adapter plug on the power cord or wall outlet.
n
DO NOT remove the ground pin from the power cord.
n
Make sure the area in front of the wall outlet into which the AC adapter is plugged is free from
obstruction.
n
DO NOT route the power cord over sharp edges or trap it between pieces of furniture. Make sure
there is no strain on the power cord.
n
DO NOT route the DC power cable that plugs into the printer over sharp edges or trap it between
pieces of furniture. Make sure there is no strain on the DC power cable.
Safety
Pitney Bowes User Guide June 2023 99

Table of Contents

Related product manuals