PLANET ECLIPSE LV1.6 - Page 27

FIG-1
FIG-3
FIG-2
FIG-4
27
ELECTRONICS
USER INTERFACE PARAMETERS
FIG-1 - FIRE MODE PARAMETER
Sets the ring mode of the marker.
> SEMI: 1 shot per trigger pull.
> RAMP: Ramping, multiple shots per trigger pull
under certain conditions. See page 28.
FIG-2 - ROF CAP PARAMETER
The maximum rate of re the marker can achieve.
> ON: ROF limited to the BS ON ROF value.
> OFF: ROF limited by loader speed.
FIG-3 - BS ON ROF PARAMETER
Sets the maximum rate of re the marker can
achieve with the breech sensor (BS) enabled.
This parameter is only available if the ROF CAP is
set to ON.
> Range: 4.0 - 30.0 bps (balls per second)
In 0.1 increments.
1
1 Always calibrate your ROF CAP parameters to the local eld
meter for consistency.
FIG-4 - BS OFF ROF PARAMETER
Sets the maximum rate of re the marker can
achieve with the breech sensor (BS) disabled.
This should be set to the slowest feed rate of the
loader in order to avoid chopping paintballs.
> Range: 4.0 - 15.0 bps (balls per second)
In 0.1 increments.
1
1 Always calibrate your ROF CAP parameters to the local eld
ROF meter to avoid penalties.