User Manual of WAP-200N/WBS-200N
-36-
Step 5. If the connection range exceeds 1km, go to the “Wireless Wireless Advanced Settings” page to
configure the distance parameter between two sites.
(3) In PtP, the distance must be configured to the same at both sites.
(4) In PtMP, the distance at each slave nodes must be configured to the actual distance from each slave node to
the master node; as to the master node should be configured to the value of the farthest node. In PtMP
application, the distance from each node to master node should not have too much deviation to ensure the
connection stability.
To Next Page
