The power button must be pressed before starting the control software or
after a prompt from the control software.
Lid button
To open the lid, press the lid button. The lid opens only when the button is
constantly illuminated. The button illumination signals that all drives of the
milling unit are at a standstill.
Hold down the lid button when opening the lid.
EMERGENCY STOP switch
The EMERGENCY STOP switch implements the fastest possible milling unit
stop. Pressing the switch stops all drives immediately and the power
electronics are disconnected from the power supply. After it is pressed, the
EMERGENCY STOP switch remains latched.
NOTE
IMPORTANT INFORMATION!
After pressing the EMERGENCY STOP switch, before disengaging the
EMERGENCY STOP switch, make sure that all faults have been remedied.
Turn the EMERGENCY STOP switch to the right to disengage it.
8 Operating milling unit
User's manual Planmeca PlanMill 50 S 47
To Next Page
Loading...
