1. POWER button
2. Lid button
3. EMERGENCY STOP switch
8.7 Processing modes
NOTE
It is essential to thoroughly clean the interiors of the milling unit when
changing from dry to wet or from wet to dry processing to prevent the build-
up of material residue in order to ensure the proper functioning of the
system.
8.7.1 Dry processing
NOTE
Extraction systems from Planmeca are only suitable for dry dust! The
extraction systems supplied by Planmeca are intended to vacuum dry milling
dust only. Do not vacuum cooling liquid residue with the extraction systems
supplied. This can lead to serious damage and even destruction of the
extraction system.
8 Operating milling unit
48 Planmeca PlanMill 50 S User's manual
To Next Page
Loading...
