4. Tighten the three middle screws using an Allen key.
7.2 Adapters for premilled abutments
Before milling adapter calibration pieces, ensure that the milling unit is
calibrated properly. See section "Calibrating milling system" on page 88 for
more information.
Pins for calibrating adapters can be ordered from your local premilled blank
supplier.
The calibrating file for milling test pins is available from your local dealer and
after installing can be found from folder
C:\NC_Daten\Planmeca Plan Mill 50
S \Adapter Calibration
.
7.2.1 DESS adapter
7 Adapters
34 Planmeca PlanMill 50 S User's manual
To Next Page
Loading...
