3.28
9924871 R03 - 2014 Polaris Sportsman® 570 EFI Service Manual
© Copyright 2013 Polaris Sales Inc.
15.Install and torque the stator cover fasteners in
sequence to specification.
Stator Cover and Water Pump Cover:
9 ft-lbs (12 Nm)
16.Measure the installed height of the new mechanical
seal as shown below. If not within specification,
remove and discard the mechanical seal and properly
install new mechanical seal as outlined in this
chapter.
Mechanical Water Pump Seal Installed Height:
0.280” - 0.287” (7.2 +/- 0.1 mm)
17.Install the water pump impeller (4).
NOTE: The water pump impeller (4) uses reverse
(LH) threads. Finger tighten only.
18.Install a new water pump cover gasket.
ENGINE
To Next Page
Loading...
