3
3.29
9924871 R03 - 2014 Polaris Sportsman® 570 EFI Service Manual
© Copyright 2013 Polaris Sales Inc.
19.Install the water pump cover to the stator cover.
Torque all fasteners in sequence to specification.
Stator Cover and Water Pump Cover:
9 ft-lbs (12 Nm)
20.Install the oil dipstick.
21.Install the coolant hose to the water pump cover and
tighten hose clamp.
22.Connect the stator wire connector and securing the
wiring to the front engine mount bracket.
23.Install the CPS sensor into the stator cover. Inspect
CPS O-ring and replace if needed.
24.Install the seat, right side panel and footwell.
25.Connect the (-) negative battery cable.
26.If the engine oil was contaminated during this service
procedure, perform an engine oil change as outlined
in Chapter 2. DO NOT run the engine until coolant
has been added to the cooling system.
27.Fill cooling system with recommend coolant and
bleed the system of air as outlined in this chapter.
28.Check for leaks.
ENGINE
To Next Page
Loading...
