EasyManuals Logo

Polaris RANGER ETX 2016 User Manual

Polaris RANGER ETX 2016
581 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #69 background imageLoading...
Page #69 background image
2
9926806 R03 - 2015 - 2016 RANGER ETX / 570 2-SEAT 2015 - 2016 RANGER 570 CREW Service Manual
© Copyright Polaris Industries Inc.
2.25
ENGINE
ENGINE OIL LEVEL - 570
Access the oil dipstick and fill tube from the right side of
the vehicle. A rising oil level between checks in cool
weather driving can indicate contaminants such as gas
or moisture collecting in the crankcase. If the oil level is
over the full/safe mark, change the oil immediately.
1. Set machine on a level surface.
2. Clean the area around the dip stick.
3. Remove dipstick and wipe dry with a clean cloth.
4. Reinstall dipstick completely.
NOTE
The dipstick must be screwed completely in to ensure
accurate measurement.
5. Remove dipstick and check the oil level. The oil level
should be between the top line and the bottom line
on the dipstick. Add oil as indicated by the level on
the dipstick. Do not overfill.
NOTE
Rising oil level between checks in cool weather driving,
can indicate moisture collecting in the oil reservoir. If
the oil level is over the full mark, change the oil.
OIL AND FILTER CHANGE - 570
Always change the oil and filter at the intervals outlined in
the Periodic Maintenance Chart. Always change the oil
filter whenever changing oil.
Oil Filter Torque:
Turn by hand until filter gasket contacts sealing
surface, then turn an additional 3/4 turn
Oil Filter Wrench:
PV-50105
Recommended Engine Oil:
Polaris PS–4
Synthetic 5W-50
NOTICE: Care must be taken to ensure that the fluids
are contained. Be prepared to collect the fluid with
suitable containers before opening any compartment
or disassembly of any component containing fluids.
CAUTION
Personal injury can occur when handling used oil. Hot
oil can cause burns or skin damage.
1. Place vehicle on a level surface.
2. Place the transmission in PARK (P).
3. Clean area around drain plug at bottom of oil pan.
4. Start the engine. Allow it to warm up at idle for two to
three minutes.
5. Stop the engine.
6. Place a drain pan under the crank case.
7. Remove the drain plug
q
. Allow oil to drain
completely.
MAINTENANCE

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Polaris RANGER ETX 2016 and is the answer not in the manual?

Polaris RANGER ETX 2016 Specifications

General IconGeneral
BrandPolaris
ModelRANGER ETX 2016
CategoryOffroad Vehicle
LanguageEnglish

Related product manuals