31
Reject Calls with Do Not Disturb on Multiple Lines
Use Do Not Disturb to reject incoming calls when you're busy.
Note: By default, Do Not Disturb applies to all lines on your phone. Your system administrator can
enable you to select the lines DND applies to.
Procedure
1. Select DND.
2. Select Set All to enable DND for all lines.
Reject Calls with Do Not Disturb on One Line
If enabled, you can choose to enable DND on a particular line.
Procedure
1. Select DND.
2. From the Line Select screen, select a line.
3. From the Do Not Disturb screen, select Enable.
Disable Do Not Disturb
When you’re ready to receive calls, disable DND.
Procedure
Select DND.
Reject Anonymous Calls
When your phone is registered with a BroadWorks server and you are signed into the phone with your
BroadSoft UC-One credentials, you can use the Anonymous Call Reject (ACR) feature to automatically
reject anonymous calls to your line from callers who have restricted their caller identification.
Check with your system administrator to find out if this feature is available on your phone.
Procedure
1. Do one of the following:
Select UC-One on the Home screen.
Go to Settings Features UC-One Call Settings.
2. If your phone has multiple lines, select a phone line.
3. Select Anonymous Call Reject.
4. On the Anonymous Call Reject screen, select Enabled.
When an anonymous call is placed to your phone number, the call is automatically rejected and the
caller hears a message stating that you do not accept calls from unidentified numbers. Your phone
does not ring, and you are not notified of an attempted call.
To Next Page
Loading...
Need help?
General
