Polycom 331 User Manual

54
7. Press the Ok or Cancel soft keys to accept or cancel changes.
8. Press to display the next eld in the contact’s entry.
9. Repeat steps 4 to 8 to enter the last name of the contact.
10. Repeat steps 4 to 8 to enter a contact number.
This is a required eld and it must be unique (not already in the
directory).
Entry to this eld is number as denoted by .
11. Repeat steps 4 to 8 to change the Speed Dial Index if desired.
It is automatically assigned to the next available index value.
12. Repeat steps 4 to 8 to change the Ring Type and Divert
Contact if desired.
These elds may be left blank.
For more information on diverting contacts, refer to Diverting
Calls on page Diverting Calls.
13. Repeat steps 4 to 8 to change the Auto Reject, Auto Divert,
Use , , , o r to switch between Enabled and
Disabled settings.
For more information on setting the Auto Reject eld, refer to
Rejecting Calls on page Rejecting Calls.
14. Press to end contact’s data entry.
15. Press the Yes or Cancel soft keys to accept or cancel changes.
16. Press repeatedly to return to the idle display.

Polycom 331 Specifications

General

Lines	2
Protocol	SIP
Speakerphone	Full-duplex
Type	IP Phone
Display	102 x 33 pixel graphical LCD
Network	10/100 Ethernet
Power over Ethernet	Yes (IEEE 802.3af)
Audio	G.711, G.729
Ethernet Ports	2
Power	48V DC
Headset Port	Dedicated RJ-9 headset port